Turkey's leading metal manufacturer


Certificates & Quality Policy

Certificates & Quality Policy

    As A Mactur Metal, our main principle is to provide services and products of quality that will ensure the continuity of customer satisfaction.

With the awareness of legal and customer conditions, on this path;

    As a Mactur Metal, we maintain a close relationship with all stakeholders within the framework of our ethical values and behavior rules. Thanks to an effective supplier development program, we ensure that we consistently receive high-level service and product. We believe that timely and accurate delivery of quality products can be achieved through effective communication and appropriate planning methodology both internally and externally. We benefit from an R&D center and facilities equipped with the most advanced technology to meet technological developments and new customer demands at the highest level. We apply our “0 Tolerance” health and safety initiative, which is shaped by rules and procedures that assist in keeping our employees, visitors, and community safe. We organize Management Review meetings on an annual basis to evaluate the effectiveness of our Quality Management System and revise if necessary.

Flame Resistance Test

Flame Resistance Test

The CTS / CDS sample is subjected to the flame, non-ignition of the sample is observed or in the case of the ignition, the ignition source is removed and the duration of onset is measured.

Heat Resistance Test

Heat Resistance Test

Force is applied to the surface of the sample which is placed on the heated support by a steel ball. The deformation on the sample is observed. The resistance of the material to the heat is determined.

Glow Wire Test

Glow Wire Test

The wire which is heated and glowed with excessive electrical charges is contacted with the sample surface for a certain period of time. The resistance of the material to heat and glow is determined.

Rutin Tests

Rutin Tests

The rutin test are applied to the conditioned sample of the first product that comes out from the machine. These tests are performed according to the specified test instructions.

Impact Resistance Test

Impact Resistance Test

The deformation of the conditioned sample caused by free-falling hammer from a certain height is observed. The resistance of the material to impact is determined.

Cable Support Test

Cable Support Test

The cable duct(cross sectional area>500mm2) mounted on a support is tested according to TS EN 50085-2-1 standard and the suitability of duct covers is observed.

High Voltage Test

High Voltage Test

Voltage is applied by the high voltage transformation to the aged sample by applying a humidification process for a certain period of time. The resistance of the material to electrical stress is determined.

Insulation Resistance Test

Insulation Resistance Test

A direct current voltage is applied by the electrodes to the sample aged by humidifying. The insulation resistance of the material to electrical stress is determined.